RTS DBP-4M 4 Channel Wired Beltpack 4M Headset

The Digital Beltpack (DBP) from RTS is designed to work seamlessly with their OMNEO media networking and digital party-line system. RTS' OMNEO media networking architecture allows easy and cost-effective management of media, control, and other data over standard IP networks.

The DBP 4M, like the OMNEO system, is engineered to grow as you grow, allowing you to use your current equipment as you migrate towards the world of IP communications at your own pace. Outfitted with a 4-pin male headset connection, the DBP 4M interfaces with an OMNEO Main Station via Ethernet and is powered by the Ethernet connection (PoE). That same connection makes it possible to daisy-chain up to 40 DBPs to create an extensive digital party-line for unmatched scalability.

You can run the DBP in party-line mode with an OMNEO Main Station or in portable keypanel mode with an RTS matrix (ODIN/ADAM). DBP also supports Bluetooth audio connectivity to a headset, mobile phone, or streaming device (via the recommended third-party dongles), making it easy to bring other kinds of devices into the system, and allowing the beltpack to serve as a compact “base station” on a desk while the user moves freely around the workplace.

The DBP is user-friendly with a lightweight ergonomic design and intuitive icon-based navigation menu though its over-molded ergonomic volume knobs and rubber enclosure make it rugged enough for any workplace. Plus, an IP53 rating means it's protected against dust and water spray.

RTS DBP-4M Includes:

• IP 4ch beltpack 4M headset

RTS DBP-4M Features:

• Hybrid functionality Operate DBP in partyline mode with OMS (OMNEO Main Station) or in portable keypanel mode with an RTS matrix (ODIN/ADAM) one device covers it all
• Daisy chaining Connect DBP to a PoE switch via OMS/ODIN/ADAM and up to six DBPs can be daisy chained together
• User friendly Lightweight and ergonomic design with full-color icon-based menu navigation for quick setup and intuitive operation

RTS DBP-4M Specifications:

• Power Supply
  • DC PoE: 802.3af / 802.3at
  • Maximum Power Consumption: 4.0W (PoE DC Input)
• Environmental
  • Operating Temperature:
    • -4° F – 113° F (-20° C – 45° C)
    • 5% to 90% relative humidity
  • Storage Temperature:
  • -4° F – 158° F (-20° C – 70° C)
  • 15% to 90% relative humidity
• Dimensions (LxWxD): 5.51" x 3.94" x 2.64" (140 x 100 x 67 mm)
• Weight: 0.75 lbs (340 g)
• Microphone Pre-Amplifier
  • XLR Input:
    • Electret Mic Input: -42.5 dBu Nominal
    • Dynamic Mic Input: -50 dBu Nominal
    • Frequency Response (LEC disabled): 120 Hz to 20 kHz
    • Frequency Response (LEC enabled): 120 Hz to 7.4 kHz
  • 3.5mm Input:
    • Electret Mic Input: -42.5 dBu Nominal
    • Frequency Response (LEC disabled): 120 Hz to 20 kHz
    • Frequency Response (LEC enabled): 120 Hz to 7.4 kHz
  • Bluetooth Input:
  • Frequency Response 70 Hz to 3.4 kHz
• Headphone Amplifier
  • XLR Headphone Response (150 Ohm load): 30 Hz to 19 kHz
  • 3.5mm Headphone Response (32 Ohm load): 50 Hz to 19 kHz
  • Bluetooth Headphone Response: 30 Hz to 3.4 kHz
• Aux In
  • Nominal Input: -4.3 dBu
  • Frequency Response (600 Ohm load): 50 Hz to 20 kHz
• Aux Out
  • Nominal Input: 2.2 dBu
  • Frequency Response (600 Ohm load): 25 Hz to 20 kHz
• OMNEO Ports (PoE In and PoE Out)
  • Maximum Capacity: 2 Full-duplex ports
  • Copper Connector Type: RJ-45
  • Format: IEEE 802.3 compliant
  • Copper Ethernet Speed: 100/1000 Mbps
• Bluetooth:
  • Bluetooth Version: 4.0
  • Approved dongles:
    • IO Gear GBU522
    • LM Technologies LM506
  • Range: 15 ft (5 m)
  • Audio Codec: SBC
• TFT Display
  • Active Area: 27.72 mm (wide) x 27.72 mm (high)
  • Dot Resolution: 240 x 240 pixels
  • Color Resolution: 16-bit (64K) RGB color
  • View Angle: 80° (typical, all directions)
  • Protective Lens: Anti-Glare / Anti-Reflective
• Approvals
  • CE Compliant
  • UL Certified