Product Overview
Crestron offers the HD-WP-4K-401-C 4K Multi-Window Video Processor with HDBaseT® & HDMI® Outputs.
This unit can simultaneously display up to four 4K sources on a single display. Automatically reconfigures as sources are connected and disconnected. Works standalone or integrated with a control system. Works with Crestron Connect It™ cable caddies for huddle room applications.
The HD-WP-4K-401-C enables the display of up to four video sources simultaneously on a single HD, Ultra HD or 4K display. Parallel HDMI® and HDBaseT® outputs provide flexible connectivity for the display device and other equipment. Input sources up to 4K are supported via four HDMI inputs. Fully automatic operation enables use without a control system, while enhanced operation and custom functionality can be attained through integration with a control system.
Specifications
- Video
- Windowing Modes Automatic: Displays only the active inputs (sync detected) as follows:
- Four active inputs display as quad view
- Three active inputs display as three equal sized windows (two side-by-side at top, one centered at bottom)
- Two active inputs display as side-by-side
- One active input displays full screen
- Full Screen: Displays any single input as a full screen image
- Picture-in-Picture: Displays any single input full screen with any other input as a scalable, positionable inset window
- Side-by-Side: Displays any two inputs as two equal sized, vertically centered windows
- Quad View: Displays all four inputs as four equal sized windows (two side-by-side at top, two side-by-side at bottom)
- Input Signal Types: HDMI® w/4K (DVI & Dual-Mode DisplayPort compatible)
- Output Signal Types: HDMI w/4K (DVI compatible), HDBaseT® w/4K (DM 8G+® compatible)
- Audio
- Input Signal Types: HDMI (Dual-Mode DisplayPort compatible)
- Output Signal Types: HDMI, balanced analog stereo
- Digital Formats Dolby Digital®, Dolby Digital EX, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos, DTS®, DTS-ES, DTS 96/24, DTS-HD High Res, DTS-HD Master Audio, DTS:X, LPCM up to 8 channels
- Analog Formats: Stereo 2-channel
- Digital-To-Analog Conversion: 24-bit 48 kHz
- Analog Performance: Frequency Response: 20 Hz to 20 kHz ±0.5 dB; S/N Ratio: >95 dB 20 Hz to 20 kHz A-weighted; THD+N: 90 dB
- Analog Volume Adjustment: -80 to +20 dB
- Analog Delay Adjustment: 0 to 150 ms
- Communications
- Ethernet: 10/100 Mbps, auto-switching, auto-negotiating, auto-discovery, full/half duplex, DHCP, web browser setup and control, Crestron control system integration
- USB: "INPUT 1 – 4" host ports enable basic control of the unit using Crestron Connect It devices; service port enables firmware update via USB mass storage device
- RS-232: 2-way device control and monitoring up to 115.2k baud with hardware and software handshaking
- IR/Serial: 1-way device control via infrared up to 1.1 MHz or serial TTL/RS-232 (0-5 Volts) up to 60k baud
- HDMI: HDCP 2.2, HDCP 1.4, EDID, CEC
- HDBaseT: HDBaseT Class A, HDCP 2.2, HDCP 1.4, EDID, CEC, PoE+
- DigitalMedia™: DM 8G+, HDCP 2.2, HDCP 1.4, EDID, CEC, Ethernet
- NOTE: Supports management of HDCP and EDID; supports management of CEC between the connected HDMI and HDBaseT devices and a control system
- Connectors
- HDMI INPUT 1 – 4: (4) 19-pin Type A HDMI female; HDMI digital video/audio inputs; (DVI and Dual-Mode DisplayPort compatible)
- USB INPUT 1 – 4: (4) USB Type A female; USB 2.0 host ports for TT-100 series Crestron Connect It Cable Caddies
- HDMI OUTPUT: (1) 19-pin Type A HDMI female; HDMI digital video/audio output; (DVI compatible)
- HDBT OUTPUT: (1) 8-pin RJ45 female, shielded; HDBaseT digital video/audio output (DM 8G+ compatible); HDBaseT PoE+ PSE port; Note: The HDBT output is for connection to HDBaseT or DM equipment only; do not connect to an Ethernet network
- AUDIO: (1) 5-pin 3.5 mm detachable terminal block; Balanced/unbalanced stereo line-level audio output; Output Impedance: 200 Ohms balanced, 100 Ohms unbalanced; Maximum Output Level: 4 Vrms balanced, 2 Vrms unbalanced
- IR: (1) 2-pin 3.5 mm detachable terminal block; IR/Serial output port; IR output up to 1.1 MHz; 1-way serial TTL/RS-232 (0-5 Volts) up to 60k baud
- COM: (1) 5-pin 3.5 mm detachable terminal block; Bidirectional RS-232 port; Up to 115.2k baud, hardware and software handshaking support
- LAN: (1) 8-pin RJ45 female; 10Base-T/100Base-TX Ethernet port
- SERVICE: (1) USB Type A female; Supports USB mass storage devices for firmware update
- 100-240V~2.0A 50/60Hz: (1) IEC 60320 C14 main power inlet; Mates with removable power cord, included
- Controls & Indicators
- PWR: (1) Bi-color green/amber LED, indicates operating power supplied from AC line power, turns amber while booting and green when operating
- ONLINE: (1) Amber LED, indicates online connection to a control system via Ethernet
- Display:2x20 character alphanumeric OLED; displays setup and configuration menus, signal information, customizable input/output names
- MENU: (1) Pushbutton, opens the setup menu
- Δ,V,: (4) Pushbuttons, for menu navigation and parameter adjustment
- Enter: (1) Pushbutton, applies a change
- BACK: (1) Pushbutton, steps menu back one level
- EXIT: (1) Pushbutton, exits the menu
- HDBT OUTPUT (rear): (2) LEDs, green LED indicates HDBaseT link status, amber LED indicates video and HDCP signal presence
- LAN (rear): (2) LEDs, amber LED indicates Ethernet activity, green LED indicates Ethernet link status
- 100-240V~2.0A 50/60Hz (rear): (1) Rocker switch, turns main port to unit on or off
- Power
- Main Power: 2 Amps @ 100-240 Volts AC, 50/60 Hz
- Power Consumption: 40 Watts typical; 20 Watts idle
- Power over HDBaseT: IEEE 802.3at PoE+ compliant PSE (Power Sourcing Equipment), supplies up to 25.5 Watts (Class 0-4) to power one HDBaseT PoE or PoE+ PD (Powered Device)
- Environmental
- Temperature: 32° to 104° F (0° to 40° C)
- Humidity: 10% to 90% RH (non-condensing)
- Heat Dissipation: 137 BTU/hr typical; 68 BTU/hr idle
- Enclosure
- Chassis: Metal, black finish, vented sides
- Front Panel: Metal, black finish with polycarbonate label overlay
- Mounting: Freestanding or 1 RU 19-inch rack-mountable (adhesive feet and rack ears included)
- Dimensions
- Height: 1.75 in (45 mm)
- Width: 18.97 in (482 mm); 17.29 in (439 mm) without rack ears
- Depth: 11.19 in (285 mm)
- Weight: 6.2 lb (2.9 kg)
