Atlas IED DNA2404DH 4-Channel Digital Power Amplifier, 6000W, 100V, Dante

The DNA2404DH amplifier from AtlasIED features Audinate's Dante™ digital audio input and four (4) channels of 600 watt amplification. An integral part of the IED GLOBALCOM® Communications System, the 2404DH allows a few audio zones to be added where necessary when a full 16-zone T9160 amplifier frame is not required.

The DNA2404DH is controlled with network commands for selecting input routing and configuring EQ, delay and output levels. Amplifiers may be controlled by a stand-alone GLOBALCOM® configuration utility or through the GLOBALCOM System Management Center. The internal Class-D (switching mode) dual channel amplifiers deliver 600W per channel into the rated loads (100-Volts into 16Ω). They provide higher efficiency, increased reliability, improved performance, and lower operating cost.. The amplifier card has 34dB of gain from its analog input to the speaker output. Attenuation is handled ahead of the power amplifier by DSP controls through software.

Inputs are provided for connecting up to eight (8) 540S ambient noise sensors (2 sensors for each output channel). This allows the output of each channel to be automatically adjusted in real time based on the measured ambient noise level in the zone.

The DNA2404DH features LED indicators for power, audio signals and fault status. A Form C relay is also included that indicates when a fault is present. The DNA2404DH provides 600 watts per channel for 100-volt transformer-distributed speaker systems and requires a 220 VAC power source.

Atlas Sound DNA2404DH Features:

• Includes CobraNet® Input
• Compatible with IED GLOBALCOM® systems and 3rd party Dante™ devices
• Dual-redundant Ethernet ports
• 7-band parametric EQ and a high-pass and low-pass filter per channel
• Signal delay up to 40ms on each channel
• Continuous, Real-time Ambient Noise Analysis and Automatic Output Level Control
• Four 600 watt amplifier output channels
• 100-Volt Output
• LED indicators for power, audio signals and faults
• Built-in Automatic Loudspeaker Line Testing detects Ground Faults, Breaks and Changes in Loudspeaker Loads
• Fault reports and amplifier status available over Ethernet using standard SNMP protocol
• Two inputs for ambient noise sensors for each amplifier output channel

Atlas Sound DNA2404DH Specifications:

• Output Power: 600-watts x 4-Channels at Rated Power
• Width: 19" (48.3cm) with Rack Ears
• Operating Temperature Range: +32 °F – +104 °F (0 °C – +40 °C)
• Height: 3.5" (8.9cm)
• Depth: 17" (43.2cm)
• Weight: 19.2lb (8.7kg)
• Storage Temperature Range: -40 °F – +158 °F (-40 °C – +70 °C)
• Voltage Compatibility: 220V - 240V