ETC D15 Dual 15A Dimmer Module

The ETC 7050A1001 D15 Standard Dimmer Module is designed for use in both Sensor®+ and Unison® Dimming Series modular rack enclosures. Standard Dimmer Modules provide cost-effective digital forward phase angle dimming for standard loads such as incandescent, low voltage, quartz, neon, cold-cathode and 2 and 4-wire fluorescent ballasts. The patented, high-density, dual modules feature modular installation and removal, fully magnetic circuit breakers and standard or enhanced risetime toroidal filters.

Applications:

• Incandescent lighting
• Low voltage lighting
• Quartz lighting
• Neon lighting
• Cold Cathode lighting
• 2-wire Fluorescent ballast
• 4-wire Fluorescent ballast

ETC D15 Features:

• Two 1.8 or 2.4kW dimmers per module
• Standard or Enhanced risetime toroidal filters
• High-density modular assembly
• Die-cast aluminum chassis
• Fully magnetic circuit breakers

ETC D15 Specifications:

• Physical:
  • Modular plug-in assemblies
  • Cast aluminum chassis, finished with textured epoxy paint
  • Keyed to prevent insertion in inappropriately rated rack positions
• Circuit Breakers:
  • Fully magnetic to eliminate nuisance tripping
  • 20x inrush current rating
  • 125%, 10-120 seconds, must-trip rating
  • Rated for 100% switching duty applications
• Ratings:
  • 100,000A Short Circuit Current Rating Rating (SCCR)
  • Modules withstand hot-patching of cold loads up to full rating
  • UL and cUL LISTED
• Power Device:
  • Sealed, patented assembly
  • Field replaceable with screwdriver
  • Two back-to-back SCRs per circuit
  • One control LED per circuit
  • Integral bonded heatsink
  • Integral temperature sensor
• Filtering:
  • High quality toroidal filters: 350µS risetime - Standard 100-120V modules
  • * Risetime measured at full load, at worst case firing angle (90°), from 10-90% of output wave form
• Dimmer Range:
  • Incandescent, low voltage dimming range 100-0%
  • Dimming range of 2 and 4-wire fluorescent ballast is dependent on lamp ballast combination. Contact ETC for range verification
  • Sizing of Neon transformer used in dimming applications should be 1.5x greater than size used in non-dimming application