Pathway Connectivity 1004 16-Channel eDIN Demultiplexer

The Pathway eDIN Demultiplexer converts DMX512 signals to 0-10VDC, or other common DC ranges, or to current-sinking control of Mark 7-type fluorescent ballasts, solid state relays or fully isolated LED fixture drivers requiring 0-10V dimming control

As well as selectable DC output, the eDIN Demultiplexer provides simple, elegant DMX control over dimmable LED drivers. It also can provide single DMX-channel control over both the driver and the mains power breaker in Mark 7-type dimmable fluorescent ballast systems.

Starting with the Rev 4 board, sinking control down to zero volts is possible, along with a new panic contact closure input. The Rev 5 board is now factory -configured for out-of-the-box sinking control of LED systems. (Rev numbers appear on the paper serial number label, and are different from the circuit board revisions.

Pathway Connectivity 1004 Demultiplexer Features:

• Contact Closure "panic" input drives all outputs to full
• 16 analog outputs
• Selectable 0-10, 0-15, 0-2.5, & 0-5V output modes, or fully user-customized min/max
• Selectable current sink output
• 10mA current source per channel
• 30mA current sink per channel (Rev 5 and above)
• User-set DMX start address for easy daisy-chaining of modules
• RDM discoverable and configurable
• LED display and pushbuttons for configuration
• 2500V DMX input signal opto isolation
• 250V DMX fault protection
• End-of-line termination switch
• Status LEDs for power, DMX input
• Pluggable screw terminals for all connections
• DMX pass-thru connector
• Snap-on DIN rail housing
• DIN rail mounting section included

Pathway Connectivity 1004 Demultiplexer Specifications:

• Output Rating:
  • 10 VDC nominal, 16 VDC maximum
  • 10mA current source per channel
  • Rev 5 boards and above: 30mA current sink per channel
  • (For earlier Rev numbers, please check with the factory.)
• Power Supply:
  • 9-30V DC, 5W supply required.
  • Use eDIN 1001 power supply or equal
• Isolation:
  • 2500V opto isolation
  • 250V fault protection
• Size: 3.5” x 6” x 1.25” (90mm x 152mm x 30mm )
• Mounting: 35mm x 7.5mm DIN rail (included)