Kemper POWERRACK+REMOTE Profiler PowerRack + Remote 600W Rackmount Profiling Guitar Amplifier Head with Remote Foot Controller

The Kemper Profiler PowerRack adds a built in 600 Watt power amp to the Kemper Profiler concept and turns the former recording solution into the most versatile guitar amplification system ever. Utilizing the Kemper CabDriver mode, guitarists now have the choice of playing through regular guitar cabinets or full range monitor systems. This extends the Kemper Profiler concept as the perfect solution for the rehearsal room and the stage.

Included with the Profiler PowerRack in this offering is the Kemper Profiler Remote foot controller. This easy-to-operate floor board is tightly integrated with the Profiler PowerRack and allows you to control, administer, and program without knowledge of MIDI or needing to pore through highly technical data sheets. (For more information on the Kemper Profiler Remote foot controller, see below .)

About the Kemper Profiler PowerRack

The Kemper Profiler PowerRack 600 Watt Class D amplifier was carefully selected for the guitar amplification system to guarantee utmost performance. After extensive listening tests, a lot of measuring and looking thoroughly at the typical sonic behavior of power amps for guitar amplification on the market, it became clear that only the best components are capable of delivering impressive results.

The Amplifier delivers 600 Watts at 8 Ohm, 300 Watts at 16 Ohm, does not heat up (temperature can be monitored on display) and is lightweight.

About the Kemper Profiler Remote Foot Controller

The Profiler Remote's large, illuminated display is designed to be looked at from a distance and its housing is built like a tank.

Five buttons allow you to directly access five different programs ("Rigs") and entire performance programs can be switched using a bank system. There are dedicated buttons to access the tuner, tap tempo in and enable the exclusive Looper Effect.

The Remote connects via a single Ethernet cable to your Profiler. No extra power supply in needed and the included cable is 7 meters long (21 ft). Longer cables can be used as well (sold separately).

Up to four continuous foot pedals can control multiple parameters inside your Profiler. Four buttons switch of stomps and effects. The programming required is easier to learn than putting a new contact into your cell phone. Click to choose, assign, done.

Kemper Profiler Remote Features:

• The Looper - With a single click on a button, Remote turns into a fully-fledged Looper control station. Loops can be recorded, overdubbed, and deleted by using the buttons on the board. You can reverse, halftime, and undo takes. The maximum duration of a loop is thirty seconds. The Looper is exclusively available to Remote users.
• Programming Remote - Four buttons, which can be assigned individually for every program, can control multiple stomp effects at the same time. In order to associate an effect with a button, all you need to do is: Press a stomp button on your Profiler and hold the button of your choice on Remote at the same time. Done.
• Made with touring in mind - Remote connects to Profiler with a single cable. Kemper uses a Neutrik® etherCON® connector to ensure the most robust connection possible on stage. By using a powered ethernet hub, distances in excess of 100 meters (300ft) can be bridged with a simple Ethernet cable.
• Controllers and switches - The four TRS connectors on the rear panel can be used for continuous controllers and switches. Each controller can be freely assigned per program. Multiple assignments per controller are also possible. Status color LEDs give you a great overview on assignments and purpose of a switch/pedal.
• Administer other equipment - Remote allows you to control external MIDI gear by sending program change messages utilizing the MIDI output of your Profiler.