Product Overview
The Leviton PE300-D0W Power Extender allows a dimming zone’s power handling capacity to be extended to full control of a 20A circuit. The PE300 will drive 0-10VDC dimmable fluorescent ballasts such as Advance Mark VII 0-10V, OSRAM Sylvania Quicktronic Helios, or equivalent ballasts.
Leviton PE300-D0W Features:
- Works with low-voltage non-dimmable and dimmable electronic ballasts, such as Advance Mark VII 0-10V, OSRAM Sylvania Quicktronic Helios, or equivalent ballasts
- Low-end trim available for setting the minimum brightness level
- Will emulate the characteristics of the dimmer that it is connected to in terms of dimming range and resolution
- Works with any Dimensions® Multizone Controller to extend load capacity on any zone
- 0-10V Max Sink Load: 200mA (~100 ballasts)
Leviton PE300-D0W Specifications:
- Device Type: Power Extender
- Electrical
- Load Type: 0-10VDC Ballast Only
- Load Rating: 20A 2400VA 120VAC, 5500VA 277VAC
- Voltage: 108VAC to 305VAC, 60Hz
- Power Consumption 6W at 120VAC max., 18W at 277VAC max.
- Control Input: 120 Volt 50/60Hz
- Load Output: 0-10VDC Ballast Control
- Physical
- Color: Silver
- Dimensions (LxWxH): 4.3" x 4.0" x 3.6" (10.92cm x 10.16cm x 9.14cm)
- Compliance
- Standards and Certifications: UL Listed, CSA Certified and FCC Part 15
- Environmental
- Operating Temperature Range 32ºF to 151ºF (0ºC to 55ºC)
- Storage Temperature Range 14ºF to 185ºF (-10ºC to 85ºC)
- Relative Humidity 20%-90% non-condensing
- Warranty
- NOTE: If dimmer has a Neutral wire it must be connected.
- For more information and specifications, please refer to items under the "Documentation" tab. All specifications and information subject to change without notice.