DPA MMP-F30 30cm (11.81") Modular Podium Boom Arm with Gooseneck and Preamplifier

A 30 cm long modular podium boom arm with gooseneck top and microphone preamplifier, DPA Microphones' MMP-F30 is engineered for use with any of DPA's modular microphone capsules. The MMP-F30 comes with a state-of-the-art preamplifier design and features excellent radio frequency rejection thanks to the DPA-designed impedance balancing with an active drive.

DPA Microphones MMP-F30 Features:

• Maximum speech intelligibility regardless of acoustical environment
• High-gain before feedback leading to fewer speaker placement issues
• Rejection of mobile phone interference
• Consistent sound from every microphone, every time

DPA Microphones MMP-F30 Specifications:

• Output Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
• Low-Cut Frequency, -3 dB: 15 Hz
• Noise with Shorted Input, A-weighted: 0.6 µV
• Output Voltage, RMS: 2.2V
• Output Voltage, Peak: 3.1V
• Type of Electronic Circuit: Active
• THD @ 1VRMS, 1kHz: < 0.2 %
• Dynamic Range: 131 dB
• Output Impedance: 100 Ohms
• Minimum Load Impedance: 2 kOhms
• Current Consumption: 3.5 mA
• Output Balance Principle: Impedance balancing
• Common Mode Rejection Ratio (CMRR): > 40 dB
• Power Supply (for full specifications): 48 V Phantom power (+/- 4 V)
• Cable Drive Capability: 328ft (100m)
• Color: Matte Black
• Diameter: 0.75" (19 mm)
• Length: 30 cm
• Temperature Range: -40 °F to 113 °F (-40 °C to 45 °C)
• Relative Humidity (RH): Up to 90%