Product Overview
The MXWANI Audio Network Interface streamlines microflex wireless connectivity to conference room AV systems over 8 channels to enable easy set up. This interface's features include corporate uplink mode and Dante networking to transport low-latency digital audio.
Features
- Four port gigabit switch: Optimized port configurations for connection to the Access Point Transceiver and Networked
- Charging Stations, third party control systems, and corporate networks
- Ethernet connectivity: Send audio and control signals over long cable runs of up to 300 feet or anywhere over a corporate network
- Power over Ethernet: Port 1 of the rear panel switch supplies power over Ethernet to the Access Point Transceiver for simplified installation
- Corporate uplink mode: Link to the corporate network for remote control of system settings while keeping audio off the network for security and to reduce bandwidth
- Front panel controls: Mute or solo channels and set input/output levels easily from the front panel
- PC/Mac software control: Access the Microflex Wireless Control Software from a networked computer for input/output levels and port configuration
- Dante™ and AES67 networking: Transports low latency digital audio received from wireless microphones over Ethernet to any other Dante-equipped device
- Headphone output: Solo audio signal on any channel
Specifications
- Audio Frequency Response: 20 Hz to 20 kHz (+1, −1.5 dB)
- Dynamic Range (20 Hz to 20 kHz, A-weighted, typical)
- Analog-to-Dante: 113 dB
- Dante-to-Analog: 110 dB
- Output Noise (20 Hz to 20 kHz, A-Weighted, typical)
- Line: −84.5 dBV
- Aux: −95.2 dBV
- Mic: −106.5 dBV
- THD+N (20 Hz to 20 kHz@ +4dBu analog input, −10 dBFS digital input):
- Polarity: Non-inverting, any input to any output
- Dimensions (H × W × D): 44 × 483 × 366 mm (1.7 × 19.0 × 14.4 in.)
- Weight: 3.2 kg (7.1 lbs)
- Housing: Steel; Extruded aluminum
- Power Requirements: 100 to 240 V AC, 50–60 Hz, 1 A
- Operating Temperature Range: −18°C (0°F) to 63°C (145°F)
- Storage Temperature Range: −29°C (-20°F) to 74°C (165°F)
- ANALOG CONNECTIONS - OUTPUTS
- Configuration: Active Balanced
- Impedance: 310 Ω
- Clipping Level (minimum)
- Line: +26.2 dBV
- Aux: +16.2 dBV
- Mic: −3.8 dBV
- ANALOG CONNECTIONS - INPUT(S)
- Configuration: Active Balanced
- Impedance: 10.6 kΩ
- Clipping Level (minimum)
- Line: +23.8 dBV
- Aux: +10.8 dBV
- Headphone Output: 6.35 mm (1/4") TRS, 100 mW, 350 Ω, dual mono (will drive stereo phones)
- DIGITAL SIGNAL PROCESSING
- AD/DA Converter: 24-bit, 48 kHz
- Latency (Estimated Nominal, ±0.1 ms)
- Analog-to-Dante: 0.21 ms
- Dante-to-Analog: 0.24 ms + TN
- TN = Network latency in milliseconds, as set in Dante Controller.
- (Note: Dante network latency is typically associated with the receiving device)
- NETWORKING
- Network Interface: Four-Port Gigabit Ethernet Switch, Dante digital audio
- Uplink Port (Port 4): Selectable, blocks multicast traffic
- Power over Ethernet (PoE): Provided on Port 1 to power MXWAPT
- Cable Requirements: Cat 5e or higher, shielded, 100 m maximum between network devices
- Network Addressing Capability: DHCP, link-local, static
