Doug Fleenor Design RR-4IN-8OUT DMX Roto-Router, Rack Mountable, 4-Inputs, 8-Outputs

The Rotor-Router is a DMX512 distribution system featuring up to 12 inputs and an unlimited number of outputs. A system typically consists of an input module and one or more output modules. Both modules are 1.7"h x 19"w x 12"d and are normally rack mounted. A plexiglass security cover is included to prevent accidental switch changes.

Doug Fleenor Designs RR-I/O DMX Roto-Router Specifications:

• Input Module
  • Input circuit: EIA-485 receiver with 120 ohm termination resistor between +Data and -Data.
  • Input connectors: Gold plated 5 pin male Neutrik D-1 series (terminal connections optional).
  • Output circuit: EIA-485 transmitter with 60 ohm series (source) termination (DMX512 signals on a non-standard connector).
  • Output connector: DB-25P. (male)
• Output Module
  • Input circuit: EIA-485 receiver. A termination plug is required if the output module is separated from the input module by more than six feet.
  • Input connector: DB-25P (male)
  • Output circuit: EIA-485 transmitter
  • Output connectors: Gold plated 5 pin female Neutrik D-1 series (terminal connections optional)
  • Isolation: 2500 volt optical coupler, 1500 volt split bobbin transformer
  • Power input: 100 - 120 volts, 50/60 hertz, 12 watts (208- 240 volt optional)
  • Size (HxWxD): 1.74" x 19" x 12"
  • Weight: 9 pounds

NOTE:

This product uses slew-rate-limited output drivers. Slew-rate-limited drivers minimize EMI and reduce reflections caused by improperly terminated cables.