Product Overview
Analyzes and alerts the user to time-code gremlins such as repeated frames, drop outs, jitter, wow and flutter, video drifting, and phase errors. Optional generator software can repair bad time code and generate new ones.
Features
- Large eight-digit reader
- Status/Warning LEDs
- Time-code repair via Ethernet
- Buffered outputs
- In REPAIR mode, the SR-112 fixes drop outs by regenerating the incoming code (jam-sync). It can also correct video phase when it is misaligned.
Specifications
- Distributor Configuration
- 1 x 12:
- 8 x DSub25 (Tascam/Avid analog pin configuration)
- 2 x XLRM
- 2 x TRS
- Input Signal
- Format: SMPTE/EBU Longitudinal Time Code
- Impedance:
- 20 kOhm balanced
- 10 kOhm unbalanced
- Level:
- -30 dBU min.
- +20 dBU max.
- Output Signal
- Waveform: Switchable rise time
- 1 us (square)
- 25 us (SMPTE)
- 50 us (EBU)
- Impedance:
- 600 Ohm balanced
- 300 Ohm unbalanced
- Level: adjustable
- full off to +8 dBU balanced
- full off to +2 dBU unbalanced
- Amplitude Distortion: less than 2%
- LED's
- Status LED's:
- Reshape
- Repair (TCGoption)
- Generate (TCG option)
- TCIn
- Video In
- Ethernet
- Warning LED's:
- Input Error: Red
- VideoPhase: Yellow
- Video Drift: Red
- VideoTermination Off: Yellow
- Display
- Time Code Reader: The 8-digit LED display indicates hours, minutes,seconds, and frames. The display also flashes error descriptions when detected.
- LCD Display: In addition to be used for SET UP, the 32 character LCD display indicates the following:
- Format and rate of the incoming time code
- Format and rate of the video reference
- User Bits
- Video Phase
- List of errors
- Connectors
- Time Code In: 1 x XLRF
- Video Reference: 1 x BNC
- Time Code Outputs:
- 1 x DB25: Outputs 1-8, Tascam/Avid analog pin configuration
- 2 x XLRM: Outputs9-10
- 2 x 1/4" TRS jacks: Outputs 11-12
- Ethernet: RJ45
- Power: 2 x 4-pin circular
- Power
- Dual Redundancy: Two separate 12VDC supplies can be connected to the 2 separate power inputs. In the event one failes, the other takes over and anerror is reported. Then, simply change the faulty supply.
- Power Supply Requirement: 12VDC @ 18W min.
Note: TCG firmware option is available for an upcharge. Please contact your sales associate for additional information and pricing.