Product Overview
The TP-582T is a high-quality twisted pair transmitter for HDMI, Ethernet 100BaseT, bidirectional RS-232 and IR signals. The TP-582T selects one of two HDMI inputs, and converts it with the Ethernet 100BaseT, RS-232 and IR input signals to a twisted pair signal. The TP-582R converts the twisted pair signal back to Ethernet 100BaseT, RS-232, IR and two HDMI outputs, and de-embeds the audio to S/PDIF and TOSLINK® audio outputs.
Features
- Max Data Rate - 2.25Gbps
- HDTV Compatible
- HDCP Compliance
- HDMI Support - HDMI (V.1.4 with Deep Color,x.v.Color™, Lip Sync, HDMI Uncompressed Audio Channels, Dolby TrueHD, DTS-HD,CEC).
- 3D Pass-Through
- EDID Pass Thru - Passes EDID/HDCP signals from source to display.
- Bidirectional RS-232 Interface - Commands and data can flow in both directions via theRS-232 interface, allowing status requests and control of the destination unit.
- Ethernet Interface - Passes 100 BaseT.
- System Range - Up to 100m (330ft).
- Cable - Requires shielded twisted pair (STP) cable. For optimum range and performance use, useKramer's BC-DGKat524, BC-DGKat623 and BC-DGKat723 cables. Note that the transmission range depends on the signal resolution, graphics card and display used. The distance using non-Kramer CAT 5, CAT 6, and CAT 7 cables may notreach these ranges. Use only shielded cable where both ends of the shield are soldered to ground.
- Control - Front panel
- Indicators- Status LEDs for input selection, output, link and power.
- Compact MegaTOOLS - 2 units can be rack mounted side-by-side in a 1U rack space with the optional
Specifications
- Inputs: 2 HDM Iconnectors, 1 IR on a 3.5mm mini jack, 1 Ethernet 100BaseT on an RJ-45connector, 1 RS-232 on a 9-pin D-sub connector, 1 remote contact closure on a terminal block connector
- Output: 1 RJ-45connector
- Bandwidth: Supports up to 2.25Gbps bandwidth per graphic channel
- Compliance with HDMI Standard: Supports HDMI and HDCP
- Dimensions: 7.4" x4.5" x 1.0"