Ashly KLR-2000 Stereo Power Amplifier, 1000W at 2 Ohms

The Ashly KLR-Series amplifiers are high-efficiency, lightweight, two-channel, high power amplifiers incorporating the latest technologies delivering quality and value for professional quality performance at an extremely affordable price. Whether your application is professional audio or fixed performance installation, KLR amplifiers are optimized to provide reliable audio performance with sonic perfection.

Covering a power range from 1000 to 2000 watts per channel at 2 ohms (20Hz-20kHz, 1% THD), the KLR-2000, KLR-3200, and KLR-4000 are perfectly suited for a wide range of sound reinforcement. All three KLR amplifiers are optimized to deliver high levels of sustained power, extraordinary audio performance, and road-proven reliability into 2, 4, or 8 ohm loads and are housed in a a uniform, rugged 2RU chassis. Each KLR amplifier uses a state-of-the-art Switch Mode Power Supply which assures you of flawless lows, punchy mids and pristine highs. The output topography of the KLR-2000 and KLR-3200 are Class-AB, while the KLR-4000 is a two-step Class-H design. KLR-Series protection circuits include: output over-current protection, DC output protection, chassis internal temperature monitoring, inrush limiting and a mains circuit breaker.

Front panel features include: individual input attenuators, signal, clip and protect LEDs, air inflow vents with removable dust filters, power switch and power LED. Rear panel features include: balanced inputs via 3-pin Euroblock, combo XLR/ 1/4" TRS connectors, Neutrik Speakon output connectors, 3-position gain switch (1V, 32dB or 26dB sensitivity), 3-position mode switch (bridged, stereo or parallel mono), 3-position HPF switch (30Hz, 50Hz or off), on/off limiter switch, air outflow vents and permanently attached power cord.

Ashly KLR-2000 Features:

• Balanced inputs via 3-pin Euroblock and combo XLR/1/4" TRS
• Switch mode power supply provides high efficiency and low weight
• Forced air cooled (front in, rear out)
• Removable dust filters
• Front mounted attenuators
• Front panel indicators for output level, clip/protect, and power on/off
• Gain selectable switch for both channels
• Rack ears for permanent installation in a standard 2RU enclosure
• Neutrik Speakon output connectors
• 3-position gain switch (1V, 32dB or 26dB sensitivity)
• 3-position mode switch (bridged, stereo or parallel mono)
• 3-position HPF switch (30Hz, 50Hz or off)
• On/off limiter switch
• Permanently attached power cord
• Extensive protection circuitry

Note:

Please see the data sheet and operating manual found under the "Documentation" tab.