Neutrik NL4MP-B 4-Pole Speakon Chassis Connector with Gold Contacts

4 pole chassis connector. D-size flange. Air tight. Thread holes for A-SCREW, grey.

Specifications

• Electrical:
  • Rated current/contact: 30 A rms continuous, 40 A rms 1 min.
  • Dielectric strength: 4kV peak
  • Rated voltage: 250 V ac
  • Contact resistance: = 3 m ohm (= 10 m ohm for NL4MD-H) after 5000 insertion-withdrawal operations
  • Insulation resistance, initial: > 2 G ohm, afterdamp heat test: > 1 G ohm
  • Inrush/outrush current capability (12 V source):300/30 A/200 ms
  • Creepage distance: according to IEC 664-1
• Mechanical:
  • Chassis: flat tabs for FASTON 0.187" x 0.02" (4.8 mm x0.5 mm) or PCB-version with pins 1.6 mm x 0.5 mm (FASTON is a trademark of AMPInc.)
  • Solderability complies with IEC 68-2-20
• Material:
  • Contacts, Female: CuZn39Pb3
  • Contacts, Male: CuSn8, 4 µm Ag plated
  • Housing: PA 6 30% GR
  • Metal insert: Ck67
  • Temperature range: -30°C to +80°C
  • Flammability: UL94HB
• Amplifier Wiring:
  • Stereo ("HIFI"): one NL4MP socket left channel pins1+/1- right channel pins 2+/2-
  • Power ("PA) Standard: three NL4MP sockets "A" socket: left channel pins 1+/1- "B" socket: right channel pins 1+/1-
  • Bridged mono: "M" socket: left channel pins 1+/1-right channel pins 2+/2-
  • BI-Amp: one NL4MP socket low frequency pins 1+/1- high frequency pins2+/2-
• Cable Wiring:
  • Stereo ("HIFI"): NL4FC on amplifier end, four conductor cable splits into two pairs with NL4FC on each end
  • Power ("PA) Standard: a two-conductor cable for each channel with NL4FC on both ends
  • Bridged mono: a special two-conductor cable, on both ends wired to pin 1+/2+ of NL4FC
  • BI-Amp: a four-conductor cable on both ends wired to pins 1+/1-, 2+/2- ofNL4FC
• Speaker Wiring:
  • Stereo ("HIFI"): one NL4MP per speaker left speaker pins 1+/1- right speaker pins 2+/2-
  • Power ("PA) Standard: NL4MP pin 1+ to speaker coil "+"NL4MP pins 1- and 2+ to speaker coil "-"
  • Bridged mono: NL4MP pin 1+ to speaker coil "+" NL4MPpins 1- and 2+ to speaker coil "-"
  • BI-Amp: one NL4MP socket low frequency pins 1+/1- high frequency pins2+/2-