Product Overview
The Shure Microflex MX412SE/C is a cardioid gooseneck microphone that comes with an inline preamp, shock mount, flange mount, a 10-ft Side Exit (or Bottom-Exit) Cable, and a Snap-Fit Foam Windscreen.
Shure Microflex® Gooseneck microphones are fully adjustable gooseneck and can interface with interchangeable cardioid, supercardioid or omnidirectional cartridges. These cartridges offer wide frequency response and accurate sound reproduction for a wide variety of applications such as houses of worship, courtrooms, and conference centers.
Includes
- Shure MX412SE/C 12" Microflex cardioid gooseneck microphone
- In-Line Preamp
- Shock & Flange Mount
- 10 ft. Exit cable
- Snap-Fit Foam Windscreen
Features
- Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
- Interchangeable cartridges provide the right polar pattern for every application
- Balanced, transformerless output for increased immunity to electromagnetic hum and RF interference over long cable runs
- Shock mount provides over 20 dB isolation from surface vibration noise
- Locking flange mount for permanently securing microphone to lecterns, pulpits, or conference tables
- Snap-fit foam windscreen
- Supplied shock mount for more than 20 dB isolation from surface transmitted noise
- Supplied threaded flange mount for permanently securing the microphone toa lectern, pulpit, or conference table
Specifications
- Type: Electret Condenser
- Frequency Response: 50 to 17000 Hz
- Polar Pattern: Cardioid
- Output Impedance: 180 Ω
- Output Configuration: Active Balanced
- Sensitivity, @ 1 kHz, open circuit voltage: –35 dBV/Pa(18 mV), 1 Pa=94 dB SPL
- Maximum SPL, 1 kHz at 1% THD, 1 kΩ load: 124 dB
- Self Noise, A-weighted: 28 dB SPL
- Signal-to-Noise Ratio, Ref. 94 dB SPL at 1 kHz: 66 dB
- Dynamic Range, 1 kΩ load, @ 1 kHz: 96 dB
- Common Mode Rejection, 10 Hz to 100 kHz: 45 dB, minimum
- Clipping Level at 1% THD: –6 dBV (0.5 V)
- Polarity: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
- Operating Temperature: –18–57°C (0–135°F)
- Storage Temperature: –29–74°C (–20–165°F)
- Relative Humidity: 0–95%
- Power Requirements: 11–52 V DC, 2.0 mA
- Cable: 3.0 m (10 ft) , attached
