Brainstorm Electronics SR-112 Time Code Distripalyzer

Analyzes and alerts the user to time-code gremlins such as repeated frames, drop outs, jitter, wow and flutter, video drifting, and phase errors. Optional generator software can repair bad time code and generate new ones.

Features

• Large eight-digit reader
• Status/Warning LEDs
• Time-code repair via Ethernet
• Buffered outputs
• In REPAIR mode, the SR-112 fixes drop outs by regenerating the incoming code (jam-sync). It can also correct video phase when it is misaligned.

Specifications

• Distributor Configuration
  • 1 x 12:
  • 8 x DSub25 (Tascam/Avid analog pin configuration)
  • 2 x XLRM
  • 2 x TRS
• Input Signal
  • Format: SMPTE/EBU Longitudinal Time Code
  • Impedance:
  • 20 kOhm balanced
  • 10 kOhm unbalanced
  • Level:
  • -30 dBU min.
  • +20 dBU max.
• Output Signal
  • Waveform: Switchable rise time
  • 1 us (square)
  • 25 us (SMPTE)
  • 50 us (EBU)
  • Impedance:
  • 600 Ohm balanced
  • 300 Ohm unbalanced
  • Level: adjustable
  • full off to +8 dBU balanced
  • full off to +2 dBU unbalanced
  • Amplitude Distortion: less than 2%
• LED's
  • Status LED's:
  • Reshape
  • Repair (TCGoption)
  • Generate (TCG option)
  • TCIn
  • Video In
  • Ethernet
  • Warning LED's:
  • Input Error: Red
  • VideoPhase: Yellow
  • Video Drift: Red
  • VideoTermination Off: Yellow
• Display
  • Time Code Reader: The 8-digit LED display indicates hours, minutes,seconds, and frames. The display also flashes error descriptions when detected.
  • LCD Display: In addition to be used for SET UP, the 32 character LCD display indicates the following:
  • Format and rate of the incoming time code
  • Format and rate of the video reference
  • User Bits
  • Video Phase
  • List of errors
• Connectors
  • Time Code In: 1 x XLRF
  • Video Reference: 1 x BNC
  • Time Code Outputs:
  • 1 x DB25: Outputs 1-8, Tascam/Avid analog pin configuration
  • 2 x XLRM: Outputs9-10
  • 2 x 1/4" TRS jacks: Outputs 11-12
  • Ethernet: RJ45
  • Power: 2 x 4-pin circular
• Power
  • Dual Redundancy: Two separate 12VDC supplies can be connected to the 2 separate power inputs. In the event one failes, the other takes over and anerror is reported. Then, simply change the faulty supply.
  • Power Supply Requirement: 12VDC @ 18W min.

Note: TCG firmware option is available for an upcharge. Please contact your sales associate for additional information and pricing.