Milab SRND-360
Coincident Surround Microphone

SRND-360

Milab's SRND 360 is built around three matched DC196 rectangular capsules.  These capsules are used as cardioids and placed at 120º to each other.  The SRND-360 is intended for recording directly to 5.0/5.1 and 6.0/6.1 surround systems. 

By combining the signal from two adjacent cardioid capsules, a "virtual" output is created in-between them.  Subtracting the proper amount of the signal from the opposing real capsule would give this virtual output a cardioid pattern, which is identical to the "real" outputs.

The SRND 360 combines its three real capsules in different configurations to produce 6 individual cardioid outputs at 60º to each other.  These outputs can be used in a wide variety of stereo, multichannel and surround formats.

The SRND-360 comes with:

• Microphone
• Power Unit
• 24V AC power adapter
• 5-pin XLR Cable,
• Elastic suspension with stand adapter

The system does not use 48V phantom power.  All internal power comes from the supplied AC adapter.  However, the system is protected against accidental powering from an external 48V supply.

Output Connections:

• LF = Left Front (virtual capsule)
• LR = Left Rear
• CF = Center Front
• CR = Center Rear (virtual capsule)
• RF = Right Front (virtual capsule)
• RR = Right Rear

Specifications:

• Frequency response: 20Hz - 20kHz
• Polar pattern: 6x coincident cardioid at 60° spacing
• Max. SPL (1 % THD at 1 kHz): 130 dB
• Sensitivity at 1kHz: 17.5 mV / Pa ± 1 dB
• A-weighted noise level (IEC 179-A): 12 dB
• Output impedance: < 200O
• Minimum load impedance: 1 kO
• System outputs: 6x 3-pin XLR
  pin 1: earth (Shield)
  pin 2: plus (Hot)
  pin 3: minus (Cold)
• Microphone Net weight: 685g
• Microphone Length: 120mm
• Microphone Diameter 60mm
• Control Unit Net weight: 845g
• Control Unit Size: 165mm x 55mm x 165mm

Our Part #  SRND-360