Sabine NAVRC-100
Remote Contol Panel, Wall Mount

NAVRC-100

Sabine Navigators can be controlled from the front panel, the remote control software, or the NAVRC-100 Remote Contol Wall Panel. These attractive panels mount in standard 2-gang wall-boxes, and they provide control over several Navigator functions. Each panel has a set of control buttons and a backlit LCD for displaying menus and control parameters.

Programming the wall panels is done using the Navigator Wall Panel Setup software. This PC-software allows you to create custom menus for each Navigator function, and allows for limiting the accessable range of each function. For example, you can allow for only small changes in gain at the wall panel.

• Dimensions: 4.58” wide x 4.58” high x 1.36” deep
• Minimum hole for mounting: 3.5” wide x 2.6” high
• Fits in standard 2-gang wall box
• Power is supplied by the connected Navigator

Included in the box:

• Complete controller mounted on cover plate, ready to install
• Programming port and ribbon cable

Not included but required for installation:

• CAT5 Ethernet cable - run from Navigator to NAVRC-100
• Standard 9-pin RS232 serial cable (for setup only)
• Standard 2-gang wall box and mounting screws
• PC computer with Navigator Wall Panel Setup software installed and RS232 serial connection (for setup only)

Connections:

• To Navigator: 2 RJ-45 connectors for CAT5 cable
• To Programming Port: Ribbon Connector

Connections: Programming Port

• To PC: DB9 RS232 connector
• To NAVRC-100: Ribbon Connector
• Maximum number of Wall Panels per Navigator: 32
• Maximum number of Navigators per Wall Panel: 2
• Maximum CAT5 cable length per Wall Panel/Navigator setup: 200 feet

Available Control Parameters, selectable for input or output:

• Signal Mute
• Signal Level
• Signal Polarity
• Signal Delay
• EQ Frequency
• EQ Level
• Mixer
• Program Recall (global)

Front Panel Controls

• Menu, Value, Enter, Exit

Back Panel Controls

• Dipswitches, for identifying each Wall Panel

Our Part #  NAVRC-100