Audio Engineering Assoc R44CX
Ribbon Microphone Figure-8 w/High Output +6-dB

R44CX

The AEA R44CX Has 6dB more output than the original RCA 44B and BX. Sound is slightly more forward. Red accent marking.

The R44C is a museum quality replica of the 1936-38 RCA 44, hand made by AEA using 1.8 micron ribbon material originally manufactured by RCA. Features a Black and silver "radio" finish with bright polished chrome grill, cushion mount, and a bronze investment cast yoke. R44C parts are interchangeable with the original RCA 44B and BX. Supplied with hard wired two meter XLR output cable, shock mount / mic stand adapter, and AEA 44 VC vertical case for proper shipping and storage.

Features:

• An accurate reproduction of the original RCA RibbonMic
• Uses the same ribbon material as the original
• Built to the highest studio standards possible
• A single diaphragm Figure 8 ribbon microphone
• 90dB down broadband at 90 degrees
• Custom AEA Transformer
• High SPL capability, max level is 140dB plus above200Hz
• Low Self Noise
• Consistent polar response
• Operable in high humidity environments
• Sounds equal to or better than the original RCA 44

Specifications:

• Frequency Response: Below 30 Hz to above 20 kHz
• Maximum SPL: 140 + dB SPL above 200Hz for 1% thirdharmonic
• Output Sensitivity: 2.25 mV / Pa into unloadedcircuit
• Output Impedance: 270 ohms broadband
• Recommended Load: 1.2 K ohm or greater
• Powering: Not required or recommended
• Polarity: Pin 2 high for positive pressure on thefront of the microphone.
• Connector: XLR-3M wired to a 2 meter captive cable
• Polar Pattern: Native bi-directional pattern
• Horizontal: Level changes with angle, frequencyresponse is consistent,
• –90 dB null at 90 / 270 degrees
• Vertical: Level changes with angle, reduced HFresponse above and
• below 0 / 180 degree axis, null at 90 / 270 degrees
• Ribbon Thickness: 1.8 microns ( .0000018 meter ) ofpure aluminum
• Ribbon Width: 4.7 mm
• Ribbon Length: 59.7 mm

Our Part #  R44CX