Crown CM700MP

The Crown CM700 is a cardioid condenser microphone for pro or semi-pro recording and high-quality sound reinforcement. Rugged enough for the road, the CM700 is well suited for acoustic instruments, drum overheads and studio vocals. It works equally well for popular music (multi-miking) or classical music (stereo and spot miking). Small and inconspicuous, the CM700 is also a good choice for miking a lectern. The microphone is also available in stereo matched pairs as the CM700MP.

The CM700 has a very smooth, wide-range frequency response which gives it a natural sound. It preserves the delicate timbre of acoustic instruments, yet it can reproduce all the power of a pipe organ. The off-axis response is also smooth, so any leakage picked up has little coloration.

Because of its cardioid pickup pattern, the CM700 reduces background noise, room reverb and feedback. The cardioid pattern is uniform with frequency.

Self-noise is very low, permitting clean, noise-free recordings. The mic can handle extremely loud sounds without distortion. It is protected against static and RFI. The output is balanced, low impedance, which allows long cable runs without hum pickup or high-frequency loss. Powering is by 12-48V phantom power.

Several audiophiles touches enhance the mic's pristine sound quality: an ultralight diaphragm, humbucking transformer, polycarbonate capacitors and a gold-plated 3-pin connector.

The CM700 has a bass-tilt switch with three positions: flat, low-cut and rolloff. An included 2-stage foam pop filter softens breath pops and a foam windscreen reduces wind noise outdoors.

Specifications

• Transducer Type: Back electret condenser
• Frequency Response (typical): 30 Hz to 20,000 Hz
• Polar Pattern: Cardioid
• Impedance: 190 ohms balanced
• Recommended Load Impedance: 1000 ohms
• Open-circuit sensitivity: 2.5 mV/Pa (-52 dB re 1V/Pa)
• Power Sensitivity: -52 dB re 1 mW/Pa
• Equivalent noise level (self noise): 21 dB SPL typical, A-weighted
• S/N Ratio: 73 dB at 94 dB SPL
• Max SPL for 3% THD: 151 dB with 48V phantom, 142 dB with 12V phantom
• Output connector: 3-pin male XLR-type connector
• Switch: Flat, low-cut and bass rolloff
• Current Drain: 3.2 mA
• Materials: Rugged steel housing and steel mesh grille
• Finish: Satin black
• Dimensions (Length x Head Diameter): 5.036" x .931"
• Included Accessories: Carrying pouch, WS-12 foam pop filter, WS-11 foamwindscreen, ASA-4 swivel mount