Klark Teknik DN100

The new Klark Teknik DN100 Direct Injection Box is the natural successor to the long-established LBB100.

A ground-up redesign provides an extended dynamic range, lower noise floor and all the world-class audio performance you’d expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing, which is replaceable and available as a spare part.

We’ve also fitted a Kensington security slot in one of the end panels to allow the unit to be made secure using a Kensington MicroSaver security cable.

Specifications

• Input
  • Type: active electronic, balanced or unbalanced
  • Impedance: 1M ohms nominal, balanced or unbalanced (jack connectors) 20K ohms (XLR input only)
  • Connectors: 2 quarter inch jacks and 3-pin XLR linked in parallel
  • Max. Level: 30dBu
  • Attenuator: 20dB, switchable
• Output
  • Type: Transformer Isolated, balanced
  • Impedance: 300 ohms
  • Connector: 3 pin XLR
  • Max. Level: 10dBu with load >2k ohms
  • Min. load: 600 ohms
• Performance
  • Noise: -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
  • Frequency response: +0.5/-1dB 20Hz to 20kHz
  • Distortion (THD+N): <0.01% @ 1kHz, +4dBu output
• Power Requirement
  • Voltage: +48V Phantom
  • Current consumption: <10mA
• Weight: <1kg
• Dimensions
  • Length: 142mm (5.6 inch)
  • Width: 106mm (4.2 inch)
  • Height: 60mm (2.35 inch)