Peavey IPA 1502
4 Ohm/8 Ohm/70V Single-Channel Industrial Power Amplifier

IPA 1502

Features:

• 150 Watts RMS output
• Isolated output transformer
• 70 V, 25 V, 8 or 4 Ohm loads
• Selectable subsonic filter
• Patented SPS™ protection circuitry
• Two rack spaces (rack ears included)
• Dual space port for all MMA series modules
• CE approved

Specifications:

• Rated output power: 150 Watts
• Output regulation:
  Direct out: <0.5 dB
  Transformer out: <1 dB

Frequency Response:

• Power Amplifier: +/- 0.5 dB, 20Hz-20kHz, direct out
  +/- 1 dB, 50Hz-20-kHz, transformer out
• Preamplifier: +/- 1 dB, 20 Hz-20kHz
• THD: Power amplifier: 0.05% (1 kHz) @ full power
• Preamplifier: 0.10% with nominal settings
• Power Bandwidth: Direct Out: <10Hz-20kHz
  Transformer Out: 30Hz-20kHz
• Signal to Noise: (22Hz-22kHz) typical
  All controls CCW: -100 dB
  All controls nominal: -90 dB

Outputs:

• Direct out: 4 ohms
• Transformer-isolated: Balanced 8 ohms, 25 volts, 70 volts
• Pre out: 1 Volts nominal, + 21 dBu max @ 100 Ohms
• Input sensitivity: Bridging input: Up to 100 mV @ 20 k Ohms
  Power in: 1 volt @ 20 kOhms
• Front panel controls:
  • Master level control
  • power amplifier signal presence
  • indicator
  • SPS indicator
  • Power on indicator
• Rear panel controls:
  • module input level control (use with MMA input modules only)
  • bridging input level control
  • loop switch
  • power switch
• Muting: MMA input module with muting capability overrides the bridging input
• Remote volume control (RVC) via screw terminals
• 10 kOhm approximately 30 dB of attenuation
• 100 kOhm approximately 60 dB of attenuation
• Power requirements: Domestic: 300 watts, 120 VAC, 60 Hz
• Dimensions (with rack ears): 19" W x 13.25" D x 3.45" H (483 x 337 x 88 mm)
  (without rack ears): 17" W x 13.25" D x 3.45"H (432 x 337 x 88 mm)
• Weight: 26.1 lbs. (12 kg)

Our Part #  IPA1502