DPA 5006A Surround Mic Kit with Five 4006A

The DPA 5006A is a complete DPA 4006A Surround Kit with five carefully factory-matched omni microphones. Even though the standard tolerances on DPA Reference Standards are extremely low, the surround match is even closer.

The specially selected DPA 4006A microphones are matched within ±0.5 dB on both frequency response and sensitivity from mean of set. The maximum phase response difference is 5°.

The natural sound, high sensitivity, low noise-floor and extremely linear frequency response from 10 Hz to 20 kHz (±2 dB) of the microphones make the DPA 4006As the perfect choice for all AB Stereo, Decca Tree or surround main array recordings. The precise reproduction, total transparency and natural-sounding clarity of a DPA 4006A microphone will provide you with a lifetime of satisfying listening.

The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory.

Includes

• Carefully matched microphones
• sturdy PeliTM case
• holders
• grids
• windscreens

DPA 5006A Features:

• Five carefully matched microphones
• Perfect for Decca Tree + rear omnis surround array
• Specially useful for acoustically accurate reproductions
• PeliTM Case transportation and protection

DPA 5006A Specifications:

• Directional pattern: Omnidirectional
• Principle of operation: Pressure
• Cartridge type: Pre-polarized condenser
• Frequency range: 10 Hz - 20 kHz
• Frequency range, ± 2 dB: 10 Hz - 20 kHz
• Sensitivity, nominal, ± 2 dB at 250 Hz: mV/Pa; -28 dB re. 1 V/Pa
• Equivalent noise level, A-weighted: Typ. 15 dB(A) re. 20 µPa (maks. 17 dB(A))
• Equivalent noise level, ITU-R BS.468-4: Typ. 27 dB (max. 29 dB)
• S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 79 dB(A)
• Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
• Dynamic range: Typ. 124 dB
• Max. SPL, peak before clipping: 147 dB
• Switchable attenuator: 0 dB / -20 dB
• Output impedance: < 200 ohm
• Minimum load impedance: 2 kohm
• Cable drive capability: 100 m (328 ft)
• Output balance principle: Impedance balancing with Active Drive
• Common Mode Rejection Ratio (CMRR): > 60 dB
• Power supply (for full specifications): 48 V Phantom power (± 4 V)
• Current consumption: 2.8 mA
• Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
• Color: Matte black
• Weight: 163 g (5.7 oz)
• Microphone diameter: 16 - 19 mm (0.6 - 0.75 in)
• Capsule diameter: 16 mm (0.6 in)
• Microphone length: 170 mm (6.7 in)
• Output voltage, RMS: > 5 V
• Polarity: +V at pin 2 for positive sound pressure
• Temperature range: -40 °C to 50 °C (-40 °F to 122 °F)
• Relative Humidity (RH): Up to 90%
• Matching tolerance (freqency response, sensitivity): ± 0.5 dB
• Phase deviation for kit: < 5°