Shure ULXD4
Digital Wireless Receiver G50 Band

OUR PART #:  ULXD4-G50

The Shure ULXD4 is a half-rack, networkable wireless receiver for use with ULX-D Digital Wireless Systems.
Learn More
Our Price: $875.00
List Price: $1,094.00
You save 20%!
Write the first review.
Shure ULXD4
Qty:
In Stock

Related Products

The Shure ULXD4 is a half-rack, networkable wireless receiver for use with ULX-D Digital Wireless Systems.

With an expansive set of professional features, including 24-bit / 48 kHz digital audio quality, efficient and intelligent RF performance, and AES 256-bit encryption, ULX Digital offers uncompromising wireless tailored for professional sound reinforcement.

Shure ULXD4 Features:

  • Predictive switching diversity
  • Intelligent scanning automatically finds and deploys the cleanest frequencies to transmitters over IR sync
  • Interference detection and alerts provided on both the receiver and Wireless Workbench® 6
  • Front panel gain adjustment buttons provide up to 60 dB additional gain
  • AES 256-bit encryption-enabled for applications where secure transmission is needed
  • Ethernet networking provides streamlined setup across multiple receivers,Wireless Workbench® 6 integration, and AMX/Crestron control
  • Support for frequency coordination with the Axient™ Spectrum Manager
  • Rugged metal chassis
  • Intuitive front panel LCD menu and controls with lockout feature
  • Upgraded LCD with adjustable contrast and brightness
  • Audio and RF LED meters with peak indicator
  • Remoteable ½ wave antennas
  • Furnished rack hardware

Shure ULXD4 Specifications:

  • RF Input:
    • Spurious Rejection: >80 dB, typical
    • Connector Type: BNC
    • Impedance: 50 Ohms
    • Bias Voltage: 12–13 V DC, 170 mA maximum, per antenna
  • Audio Output:
    • Gain Adjustment Range: -18 to +42 dB in 1 dB steps (plus Mute setting)
    • Configuration:
      • 1/4" (6.35 mm): Impedance balanced (Tip=audio, Ring=no audio, Sleeve=ground)
      • XLR: Balanced (1=ground, 2=audio +, 3= audio -)
    • Impedance:
      • 1/4" (6.35 mm): 100 Ohms (50 Ohms Unbalanced)
      • XLR: 100 Ohms 
    • Full Scale Output:
      • 1/4" (6.35 mm): +12 dBV
      • XLR: LINE setting= +18 dBV, MIC setting= -12 dBV
      • Mic / Line Switch: 30 dB pad 
    • Phantom Power Protection:
      • 1/4" (6.35 mm): Yes
      • XLR: Yes
  • Networking:
    • Power Over Ethernet (PoE): No, protected
    • Network Interface: Single Port Ethernet 10 / 100 Mbps
    • Network Addressing Capability: DHCP or Manual IP address
    • Maximum Cable Length: 328 ft (100 m)
  • Additional Specs:
    • Audio Frequency Response: 20 Hz–20 kHz, flat
    • Dynamic Range: 120 dB, extended
    • Tuning Range: Up to 64 MHz
    • Dimensions (HxWxD): 7.75" x 6.75" x 1.65" (197 x 171 x 42 mm)
    • Weight: 2.0 lbs (913 g), without antennas
    • Housing: Galvanized steel

Consumer Alert

This particular wireless microphone device operates in portions of the 617-652 MHz or 663-698 MHz frequencies. Beginning in 2017, these frequencies are being transitioned by the Federal Communications Commission (FCC) to the 600 MHz service to meet increasing demand for wireless broadband services. Users of this device must cease operating on these frequencies no later than July 13, 2020. In addition, users of this device may be required to cease operations earlier than that date if their operations could cause harmful interference to a 600 MHz service licensee’s wireless operations on these frequencies. For more information, visit the FCC’s wireless microphone website at www.fcc.gov/wireless-microphones-guide or call the FCC at 1- 888-CALL-FCC (TTY: 1-888-TELL-FCC).

Shure UA874 Directional Antenna with Integrated Amp, 470-698 MHz
Shure UA874 Directional Antenna with Integrated Amp, 470-698 MHz
Now you can experience improved wireless reception with Shure's UA874 Antenna. It's a UHF antenna that uses a log periodic dipole array to form a cardioid receiving pattern toward the desired coverage area, ...
355.84 374.00 5

In Stock
Free Shipping Available
Shure UA8100 100 ft UHF remote extension cable, BNC to BNC, RG213
Shure UA8100 100 ft UHF remote extension cable, BNC to BNC, RG213
The Shure UA8100 is a Remote Antenna Extension Cable BNC to BNC, RG213 type, 100 foot (30m).Compatible with: ULXS4 ULXP4 UC4 U4S U4D
216.94 255.00 15

In Stock
Free Shipping Available
Shure UA850 50 ft UHF Remote Antenna Extension Cable with BNC Connectors
Shure UA850 50 ft UHF Remote Antenna Extension Cable with BNC Connectors
The Shure UA850 50 ft remote antenna extension cable features BNC connectors and RG8X/U type cable. It is compatible with their ULXS4, ULXP4, UC4, U4S and U4D models.
101.74 103.00

In Stock
Free Shipping Available
Shure UA825 25 ft UHF Remote Antenna Extension Cable
Shure UA825 25 ft UHF Remote Antenna Extension Cable
Shure's UA825 is a 25 ft long RG8X/U-type remote antenna extension cable with BNC connectors. Compatible with ULXS4, ULXP4, UC4, U4S and U4D.
55.71 56.00

In Stock
Free Shipping Available
Shure UA806 6' UHF coaxial cable, BNC to BNC
Shure UA806 6' UHF coaxial cable, BNC to BNC
Remote Antenna Extension Cable BNC-BNC, RG58C/U type 6 foot (2m).
28.87 30.00

In Stock
Free Shipping Available
Shure UA506 Rackmount Kit for Single ULX Receiver
Shure UA506 Rackmount Kit for Single ULX Receiver
The Shure UA506 is a rackmount kit for mounting a single ULX receiver in to a standard 19" rack.
25.60 26.00

In Stock

To be the first to review this item, click here.

Add to Cart

We're sorry, only of this item available



Call a Sales Pro at 800-356-5844 for more information