(0)

Questions? Call Us:
800-356-5844

Clear-Com PS702
2 Channel Intercom Power Supply

OUR PART #:  PS702

The PS-702 can supply up to 2 amps at 30 volts DC to two channels in a 1-RU.
Learn More
Our Price: $823.50
List Price: $915.00
You save 10%!
Write the first review.

Full Compass offers free ground shipping on thousands of stock and non-stock (special order) items for orders placed on this web site and shipping in the continental US (48 states).

Learn More

Free Shipping

Available

We guarantee to match pricing on the products we sell for new, identical and immediately available products if you see them offered at a lower price. Please contact us if you find a lower price before purchasing.

Learn More

Low Price

Guaranteed

Clear-Com PS702
Qty:
In Stock

Similar Products

The PS-702 can supply up to 2 amps at 30 volts DC to two channels in a 1-RU. This is sufficient to power up to 40 beltpacks, 10 speaker stations, or 12 headset stations even under the most demanding conditions. Either channel is capable of supplying up to 1.2 amps. The full current capacity may be divided between the two channels.

Clear-Com's advanced fail-safe design can sense the difference between a short and an overload. Should a problem occur, each channel's DC overload/fault LED identifies the power supply's response to the problem: solid means an overload is sensed, but still powered; blinking means power has been temporarily cut off to protect the power supply. If both channels are operating and one channel has a fault, the other channel will continue to operate normally. Power is restored to the shorted or overloaded channel in a little as .5 seconds. With our exclusive Intelligent Fault/Overload Sensing (IFOS), the PS-702 will dynamically increase this time period before attempting another reset until the fault or overload is corrected. This function significantly extends component life. And there is no need to disconnect stations for the power supply to reset.

The unit also offers a convenient front panel intercom line jack, switchable to either channel. This can be quite handy for trouble-shooting or simply a time saver when quick access to either intercom line is needed. A 440Hz tone is available on either or both channels and is indispensable for system diagnostics and set-up. Simply flip a switch, set a level, and go.

Like all current Clear-Com Party-Line power supplies, two or more units can be connected in parallel for increased system capacity or backup redundancy. Multiple units will automatically synchronize their response to power faults and overloads. The PS-702 can also operate as a singlechannel unit by using the front-panel A+B link switch.

Clear-Com PS702 Features:

  • Provides up to 2 amps in only 1RU
  • Supports up to 40 beltpacks, 10 speaker stations or 12 headset stations
  • Exclusive IFOS Intelligent Fault/Overload Sensing for system reset
  • Front panel intercom line jack selectable for either channel
  • A+B Link switch for single channel operation
  • Balanced program input with global and individual channel controls
  • Universal power supply accepts 100-240 VAC
  • Overload/fault indicator for each channel
  • Built-in test tone generator for set up and diagnostics
  • Switchable terminations for each channel
  • Works in parallel with other power supplies and main stations
  • UL Listed and CE certified

Clear-Com PS702 Specifications:

  • Program Line Input
    • Maximum Level before Clipping: >= 20dBu
    • Input Impedance: >= 5K ohms < /UL>
    • Frequency Response
      • Program Input - Party Line: 200 - 20KHz ± 3dB
    • Max Distortion
      • Program Input - Party Line: <= 0.2% < /UL>
      • Noise
        • Program Mic Input - Party Line:< -70dBu
      • Max Gain
        • Program Input - Party Line: >= -16dB < /UL>
        • Min Gain
          • Program Input - Party Line: <= -20dB < /UL>
          • Mains Power
            • Input Voltage Range: 100 - 240 VAC
            • Input FrequencyRange: 50 - 60 Hz
            • Input Power: <= 60 VAC
            • Output Voltage: 30 VDC ±0.5V
            • Output Current per Channel (Continuous): 1.2 A
            • Output Current perChannel (Peak): 2 A (Do not exceed the 1.2A rating for more than 2 seconds per 1 minute period)
            • Short Circuit Recovery Time (1st short): <= 0.5sec
            • Short Circuit Recovery Time: >= 20 shorts in 20sec) <= 20 sec < /UL>
            • Station Capacity
              • Up to 40 RS-601 beltpacks or 10 speaker stations or 12 headset stations distributed over both channels
            • Rear Panel Connectors
              • Intercom: (6) XLR-3M (3 per channel)
              • Program:(1) XLR-3F
              • AC Power: IEC 320 connector
            • Rear Panel Controls
              • (2) Termination On-Off switches
              • (1) Volume control
            • Front Panel Connectors
              • Intercom (1) XLR-3M
            • Front Panel Controls & Indicators
              • (1) Intercom channel switch
              • (1) A+B link switch
              • (2) Program switch
              • (2) Send level controls
              • (1) Test tone switch
              • (2) Overload LEDs
              • (1) Link indicatorLED
              • (1) Power indicator LED
              • (1) Power switch
            • Environmental: 32° - 122°F
            • Dimensions (W x H x D): 19" x 1.75" x 7.5"
            • Weight: 6.16 lbs
2-Channel Belt Pack
Clear-Com RS702 2-Channel Belt Pack
The Clear-Com RS-702 is a two-channel analog beltpack with an XLR-6 line connector and XLR-4M headset connector. A mic preamp with a dynamic range of 130 db enables intelligible voice communication for every volume level, from a whisper to ...
396.00 440.00 10

In Stock
Free Shipping Available
Encore Partyline 1-Channel Analog Belt Pack
Clear-Com RS-701 Encore Partyline 1-Channel Analog Belt Pack
The Clear-Com RS-701 is a single-channel analog beltpack featuring high performance audio for use in a wide variety of environments, all within a rugged ergonomic housing.The RS-701 is a single-channel analog beltpack with an XLR-3 line ...
292.50 325.00 10

In Stock
Free Shipping Available
Programmable Intercom Source-Assignment Panel, 8x24
Clear-Com RCS2700 Programmable Intercom Source-Assignment Panel, 8x24
The Clear-Com RCS -2700 source-assignment panel is the first system available to offer remote-controlled switching of party-line assignments for medium to large size systems. The main switching unit is the RCS-2700, an 8-source by ...
2,497.50 2,775.00 10

Usually ships in 7-14 business days.
Need it sooner? Call us!
Free Shipping Available
2-Channel Wall Plate with XLR Connector for Clear-Com Beltpacks
Clear-Com WP2 2-Channel Wall Plate with XLR Connector for Clear-Com Beltpacks
The Clear-Com WP2 is a selectable two-channel wall plate that connects to single-channel beltpacks such as the RS-501. 3-pin male XLR connector with two-position channel-selector switch, allowing user to talk on either of two intercom ...
70.20 78.00 10

Usually ships in 7-14 business days.
Need it sooner? Call us!

To be the first to review this item, click here.

Add to Cart

We're sorry, only of this item available



Call a Sales Pro at 800-356-5844 for more information

© 2017 Full Compass Systems, LTD  9770 Silicon Prairie Parkway, Madison, WI 53593  All rights reserved.

We are not responsible for typographical errors in pricing or product specification
inaccuracies in our catalog or web site. Prices are subject to change without notice.