DBX ZC-4 Zone Controller with Program Selection via Contact Closure for DriveRack

This remote device provides programmable program selection via contact closures for the dbx DriveRack 220i and 260 devices. It also provides contact closure programmable source selection, page assignment, or scene selection for the dbx ZonePro devices. It has DIP switches allowing identification with connection to the processing device via CAT5 cable on RJ-45 connectors. A ZC-4 can also be used as an interface to an alarm system.

The Zone Controllers from dbx offer extended utility to the DriveRack® and ZonePRO™ families. ZC-4 and the other Zone Controllers (sold separately) use analog DC voltage to provide logic control ranging from zone source selection, volume and muting, to program or scene selection and fire safety muting. Wired with readily available and affordable Cat5 cable with universally accepted RJ-45 connectors at distances up to 1000 feet, the ZC Zone Controllers offer simple yet elegant solutions to the contractor.

Features

• Change capability from contact closures for the DriveRack 220i and 260
• Source selection, page steering, or scene selection for ZonePRO devices.
• Wall mounts up to 1000' away from your device

Specifications

• Connectors: (2) RJ-45, (1) 6-pin Phoenix
• Series Wiring Maximum Cable Length varies with number of Zone Controllers. For Example, Three Zone Controllers: 600' / Six Zone Controllers: 300'
• Parallel Wiring using ZC-BOB: Up to Six Zone Controllers: 1000'
• Parallel Wiring Cable: CAT5 or CAT5E with 28.6 Ω/M (Ω/1000') nominal DCR and rated VW-1 or higher
• Safety Agency Certifications: UL 60065, IEC 60065, EN 55013, E60065