Phantom Power Supplies

Powers up to 6 condenser microphones with 48 volts of ultra clean phantom power. The outputs are 1/4" Tip-Ring-Sleeve balanced for easy connection to a digital multi-track recorder. To eliminate the possibility of any DC voltages, it ...

The Audix APS910 Phantom Power Adapter is identical to the handy adapter that ships with Audix's electret mics: it takes anywhere between 9-52V phantom power from your audio console and adapts it for use with lavalier, hanging, ...

Phantom power adapter with XLR connector for L type MicroMic microphones with integrated bass roll-off switch.

The S-phantom gives you an in the field, on location solution for powering your condenser microphones that need 48 volt power 2 Channel 48 Volt phantom power supply2 Balanced XLR mic inputs2 Balanced XLR and 1/4" mic outputsAC adapter ...

Under the hood of this small box you’ll find the same technology that we use in our professional audio products. The Phantom Power Supply PS400 enables you to select between two different power supplies with low-noise audio ...

The CMC 6U modular microphone amplifier offers 12V or 48V, balanced output, and maximum RF rejection. The chief task of a CMC microphone amplifier is to convert the extremely high-impedance signal from the capsule to a very low-impedance ...

For situations when external power is required. Provides 48 V and can be used with one or two microphones. Female input XLR and male output XLR connectors. Dimensions: 180mm L x 130mm W x 55mm H Net weight: 600 g

Power module. Phantom or internal battery.

Power module. Phantom only.

For adapting any Galaxy headset or lapel mics to a standard XLR wired system, Phantom or Non-phantom. 3-pin TB3M Input Connector and Cannon 3-pin XLRM Output Connector. Operating Voltage: Phantom Power 9-52 V; Battery 1.5V(UM-3/AAx1) ...

2 mic inputs48V phantom powerSignal to noise ratio: 117dBReverse phase buttonStacks easily with any other Neo Processor

Phantom power supply for use with Whirlwind DSC88. The DCSP1 is a regulated low-noise 48VDC power supply that can deliver up to 500mA. Each DCSP1 provides power for up to 96 microphones when used with the SPC series splitters.

P48V battery PSU, 9V battery, XLR3. For the CS-3e shotgun microphone.

Two channel phantom power supply for the CS-3E shotgun microphone. It operates with a 9-volt battery and provides +48 phantom power. The supply also features attenuation and a low-cut filter.

Power Supply For TR50 Lavalier Mics With A 4pin Lemo Connector & Wired For Vega Wireless Systems, Negative Bias

The PPA (Phantom Power Adapter) is designed for connection of the OKM to 48volt phantom powered studio mixers or pre-amps. It provides optimum voltage for the OKMs, and transformer isolated balanced mic level inputs. The improvement in ...

Tube-style power supply for TR50 mic Single Mallory RM675 or equivalent battery Balanced output on XLR connector 18mm x 85mm Output impedance 250ohmsNote: Mic not included.

Phantom power adapter also runs on AA batteries when phantom not available. Features on-off switch and bass roll-off.

The PAEM reference phantom power module for fixed and mobile installation provides a gold-plated three-pin XLR connector. With its wide voltage range the module will fit most available microphone mixers. The module also features a 250Hz ...

A Schoeps CMC6 mic preamp (which forms the body of the microphone), includes SG20 stand clip.REQUIRES A CAPSULE, SOLD SEPARATELY The CMC 6 is designed for standard 48- and 12-Volt phantom powering. Its circuitry recognizes the supply ...