Accessories Video Lighting

For use on stand only. Allows mounting the fixture on 5/8" male stand stud. Should only be used with stands large enough to support the weight of the fixture while maintaining good balance at the desired height.

Power supply for X24 motion effects lamp.

This mirrored enclosure mounts on the front of the fixture to intensify the light and increase its output.

Small and compact, but capable of holding any TorchLED. Suction-pad mounts to virtually any flat, smooth or non-porous surface. Two ball/hinge points allow virtually any placement angle.Specifications: Size: 5.5in. x 6in. x 3in. ...

The power supply allows you to power either the TL-68 or TL-88 from an AC main.Specifications: Input Voltage: 90-240VAC 50/60Hz Output Voltage: 12vdc, 2A via TorchLED Circular Pin

For greatest control of spill, with some loss of output. For front of fixture. Approximate Output Loss: 54% Dispersion Strength Angle: 20%

Standard diffuser replacement. Must always be used to protect against lamp explosion. Size: 16" x 16" (40 x 40 cm) Weight: 6 oz. (190 g)

For greatest control of spill, with some loss of output. For front of intensifier. Approximate Output Loss: 30% Dispersion Strength Angle: 40%

For greatest control of spill, with some loss of output. For front of intensifier. Approximate Output Loss: 22% Dispersion Strength Angle: 30%

For greatest control of spill, with some loss of output. For front of intensifier. Approximate Output Loss: 46% Dispersion Strength Angle: 20%

Code: FLS-224Location: Front of FixtureOutput Loss/Gain (approx): - 25%Trims spill, but with less control & output loss than Honeycomb Grid.

Code: FLS-422Location: Front of FixtureOutput Loss/Gain (approx): + 80%This Updated mirrored enclosure, with hinged folding doors and locking leaves, when assembled & mounted on the front of the fixture, can almost double the ...

Code: FLS-434Location: Front of FixtureOutput Loss/Gain (approx): - 25%

Code: FLS-424Location: Front of FixtureOutput Loss/Gain (approx): - 25%Trims spill, but with less control & output loss than Honeycomb Grid.

Code: LC-55DSize: 21 x 21" (53.3 x 53.3 cm)Weight: 8 oz (227 g)Standard light diffuser replacements for all 3 models of Rifa-lite. Diffuser must always be used to protect against lamp explosion.

Attaches to the end of a DMX circuit for proper termination.

Stores 6 Omni lamps in foam-filled plastic case. Lamps not included.

C-clamp fitted bracket allows hanging from pipe or rail with maximum rotation & angling of fixture. Supplied with Overhead Mount Models.

This Source Four LED accessory is a Smooth Wash Diffuser that is used when extra-smooth blending of multiple Source Four LED fixtures is required. The smooth wash diffuser is placed into the gel frame slot of the lens tube. This ...

This Source Four LED accessory is a Smooth Wash Diffuser that is used when extra-smooth blending of multiple Source Four LED fixtures is required. The Smooth Wash Diffuser is placed into the gel frame slot of the lens tube. This type ...