The PB23 is for powering phantom powered microphones with either 12VDC or 48VDC. Since the unit uses a 100kHz swithcing power supply, there is no audio noise generated. It has output pull down resistors so it will work with ...

Rolls' PS27s is the main DC adapter for Rolls it outputs 15Vdc @ 200ma. has a 6 ft. cord with a DC connector on the end, tip negative barrel positive.

The PS16 supplies the DC power and distributes the Monitor signal to up to ten of the PM50s, the PM50sOB, and the PM350 units by connecting them with ordinary stereo phone cords. Although the PS16 has only 4 output jacks they can be ...

The Rolls PC3 power cord is a simple yet convenient solution to the "Wall Wart" problem. The PC3 connects between the "wall-wart" and power strip to eliminate taking up more than one outlet. It can also be used as a simple power cord ...

Perfect for any condenser microphone, the new PB224 powers even the high-current draw microphones. The unit features a complete redesign in the voltage supply circuits, offering a rock solid 48 volts of clean phantom power. The 224 now ...

Repack/Box OpenPerfect for any condenser microphone, the new PB224 powers even the high-current draw microphones. The unit features a complete redesign in the voltage supply circuits, offering a rock solid 48 volts of clean phantom power. ...

The RPM26 is a single rack space, power distribution unit supplying 9 total switched AC power outlets. Eight outlets are located on the rear panel, two of which are spaced widely so as to accommodate "wall-wart" type power adapters. A ...

Rolls AC adapter, 12V.

Powers up to 6 condenser microphones with 48 volts of ultra clean phantom power. The outputs are 1/4" Tip-Ring-Sleeve balanced for easy connection to a digital multi-track recorder. To eliminate the possibility of any DC voltages, it ...

Rolls 12 V 150 Ma. AC Adapter. This is a general purpose AC adapter for powering electronic equipment that requires a DC type plug with the tip negative 2.1mm and the sleeve positive 5mm.

The OS10 is a six-outlet, AC supply. The unit comes with a heavy-duty cord, resetable circuit breaker, lighted rocker switch, and six three-wire grounded outlets for full protection against electrical damage.

The PB223 is for powering phantom powered microphones with either 12VDC or 48VDC. Since it uses a 100kHz swithcing power supply, there is no audio noise generated. It has output pull down resistors so it will work with ...