Radio Design Labs' EZ-MCP1 is an in-line microphone compressor that produces consistent audio levels despite wide variations (up to 30 dB) from the microphone. It is installed between a dynamic or condenser microphone and a mic-level ...

The ST-VP2 can be wired into any line-level input of a paging amplifier. A line-level music source may be provided from a receiver, satellite decoder, tape or CD source. A line-level voice source may be provided from a telephone paging ...

The FP-ALC2 is the perfect choice in many applications where consistent stereo audio levels are needed from consumer sources with varying audio output levels. Power connections are made using either the full-size barrier block ...

The RU-ADL2 is a DSP based dual-output delay for an analog audio source. It provides exceptional audio performance for the most critical applications in a professional audio environment. The RU-ADL2 accepts a single monaural audio input ...

The ST-CX2S is a subwoofer signal equalizer in the STICK-ON series of products from RDL. It offers flexibility in equalization adjustment, with the exceptional performance of RDL. The ST-CX2S features two separate, isolated balanced ...

The RU-EQ2 features a balanced bridging input, which may be connected unbalanced if desired. The output driver is 150 O balanced, and is intended to drive unbalanced or balanced lines of 150 O or higher impedance. Front-panel knobs provide ...

The RU-EQ3 features a balanced bridging input, which may be connected unbalanced if desired. The output driver is 150 O balanced, and is intended to drive unbalanced or balanced lines of 150 O or higher impedance. Front-panel knobs provide ...

The FP-PEQ3 is part of the group of versatile FLAT-PAK products from Radio Design Labs. The unique FLAT-PAK case can be directly screwed or bolted to cabinets or shelves. Optionally available rack-mounting accessories permit single or ...

The FP-ALC1 is the ideal choice in many applications where consistent mono audio levels are needed from professional sources with varying audio output levels. Power connections are made using either the full-size barrier block or a dc ...

The ST-RX2 is part of a group of products in the STICK-ON series from Radio Design Labs. The durable bottom adhesive permits quick, permanent mounting nearly anywhere or it may be used with RDL's racking accessories. The ST-RX2 offers the ...

The ST-GLA1 is part of a group of products in the STICK-ON series from Radio Design Labs. The durable bottom adhesive permits quick, permanent mounting nearly anywhere or it may be used with RDL's racking accessories. The ST-GLA1 offers ...

The RU-SQ6 is the ideal choice in installations where sequential on and sequential off functions are desired. Control and output connections are made on the rear panel through full-size, clearly identified, barrier block terminals.Two ...

The ST-EQ3 is a unique audio equalizer in the STICK-ON product series by Radio Design Labs. The durable bottom adhesive permits quick, permanent mounting nearly anywhere, or use it with RDL's racking accessories. The ST-EQ3 offers the ...

The ST-FS6 is used in applications where an excessive RF level is induced in the audio cables producing audio interference in the system. It is not necessary to use all 6 input/ output channels, and wiring configurations may vary according ...

The ST-LEQ1 has two line-level audio inputs and a single line-level audio output. The audio signal to be equalized connects to the EQ INPUT. If it is desired to mix an unprocessed source with the output signal, this second source is ...

The ST-HP3 is the ideal choice where line-level audio filtering needs to be provided at the input of a power amplifier for protection of public address horns against damage from low frequencies.The ST-HP3 has one input and two filtered ...

The ST-CX2 is a line-level two band crossover to drive audio power amplifiers. The input and outputs are balanced and may be connected unbalanced if necessary. The input accepts a +4 dBu line-level signal. The module operates at nominal ...