Battery charger for current model Lectrosonics rechargeable products and power supply for some LecNet components.  110/115 VAC input; 20 VAC output; 500 mA.

Windscreen for M150 & M12 mic systems.

Power Supply for Venue Receiver; 90-240 VAC, 50/60 Hz input; 15 VDC (regulated), 1.6 A max. output, 18 W.

The RATPAC (Right Angle T connector PACkage) is a versatile kit for building a right angle connector for use with the SR receiver or Lectrosonics transmitters. The 3-pin configuration is normally used for the rear panel audio outputs of ...

The ISO9VOLT battery eliminator allows Lectrosonics wireless transmitters with hinged battery doors designed for 9 volt batteries to be operated from external power sources. 10 to 18 volt DC is converted to regulated 9 volt DC to power the ...

For use with all transmitters, including IM, LM, UM400, SM Series, SMa Series, LMa and UM400a models.  Built-in JFET active preamp for optimum interface with instrument pickups.

12" power cable, Hirose4 to DC coax connector.  For powering old Lectrosonics receivers from cameras with Hirose power connector. 

Cordura pouch with belt clip for plug-on XLR model transmitters. Velcro flap opens for access to control panel or for changing battery.NOTE: Transmitter shown is NOT included.

Coaxial cables for remote antennas.  Made with Low-loss, flexible 9913F foam-core cable and special direct-coupled connectors.  Velcro tie wraps and straight BNC connectors on both ends.Loss dB: 2

Power supply for IFB base transmitters and wireless equipment with a locking LZR power jacks.  110 VAC input, 12V DC regulated output.  400 mA max.

Adapter cable, 37", mic level, XLRF to TA5F for all 5 pin transmitters. 

The D4T transmitter can accept up to four inputs from digital or analog sources. The inputs can be configured as follows: Four balanced analog inputs using all four jacks Two digital channels using jack 1 and two balanced analog ...

The D4R receiver employs two complete RF sections for true diversity reception. The signals from both antennas are independently decoded and error-corrected, and the diversity system uses all digital data and timing reference information ...

The D4 digital 4-channel wireless system was designed as a special purpose system for location production in film and television.A typical application for this system is in television production as part of what is commonly called a ...

The ISO9VOLT battery eliminator allows Lectrosonics wireless transmitters with hinged battery doors designed for 9 volt batteries to be operated from external power sources. 10 to 18 volt DC is converted to regulated 9 volt DC to power the ...

For use with all transmitters, including IM, LM, UM400, SM Series, SMa Series, LMa and UM400a models.  Passive design for use with very high output instrument pickups such as electric bass guitars with 18 volt systems.

110 VAC adapter/power supply for most Lectrosonics wireless receivers.  12V DC output.

The ISO9VOLT battery eliminator allows Lectrosonics wireless transmitters with hinged battery doors designed for 9 volt batteries to be operated from external power sources. 10 to 18 volt DC is converted to regulated 9 volt DC to power the ...

For use with all transmitters, including IM, LM, UM400, SM Series, SMa Series, LMa and UM400a models.  Passive design for use with very high output instrument pickups such as electric bass guitars with 18 volt systems.

Snug fitting pouch protects SM housing and provides a belt clip.  A clear window allows viewing and changing settings with the pouch attached. Included with the purchase of a SM Digital Hybrid Wireless™ transmitter.NOTE: ...